Elevator cabin stress load cell:UC-H-1.2T/3T
Description:
The installation of the load weighing sensor UC-H is made normally for new installations, given the complexity of its positioning. Although it is themost complex to install, it is the most precise,since we make a scale of the cabin, where there is no influence of external mechanical agents, as the guides or the compensation chain. This cabin compression over Load cell UH-C comes with Anti vibration rubber pad mounting & this provides Dampening effect .
Note: Under cab sensors UC-AP series are not recommended for lift modernization or retrofit.
- Compression Load cell specially designed for the Installation under cabin
- (placed in the center)
- quipped with silent-block pad to avoid the transfer of vibrations.
- It can be connected to any unit control on the Series OMS, except OMS-620S and OMS-920S
- Under cab sensors are not recommended for modernization.
| Model | UC-H |
| Rated Load | 1200kg/3000kg |
| Sensitivity | 2.0+-0.02%mv/v |
| Total error | +/-0.5% F.S |
| Excitation | 5-12V DC |
| Creep Error | +/-0.02% F.S |
| Insulation Impedance | ≥5000 Ohm |
| T C SPAN | +/-0.02% F.S./10 degree Celsius |
| Operation temperature range | -30 to 70 degree Celsius |
| Input Resistance | 760+/-10 ohm |
| Output Resistance | 700+/-2 ohm |
| Safe Overload | 150% F.S. |
| Ultimate Overload | 200% F.S. |
| Construction | Alloy Steel |
| Protection Class | IP68 |
| Cable Length | 8M |
For traction elevator lifts, We SUMMIT provide a wide range of elevator load weighing device and it can suit different installation position requests, and usually there are 4 ways to mount it:
- Under elevator cabin (cab load cells)
- Clamped on the wire rope (wire rope load cells)
- Between the wire rope hitch plate such as RHP-E, RHP-F, RHP-G and so on. the customized load cells are available on requests(rope hitch compression load cells)
- Mounted on the elevator car frame to detect the beam deformation (tension link load cell, cross head load cell)
